Foxconn 955X7AA series User Manual page 36

Clear CMOS Jumper: CLS_CMOS
This motherboard uses the CMOS RAM to store all
the set parameters. The CMOS can be cleared by
removing the CMOS jumper.
How to clear CMOS?
1. Turn off the AC power supply and connect
pins 1 and 2 together using the jumper cap.
2. Return the jumper setting to normal (pins 2 and
3 together with the jumper cap).
3. Turn the AC power supply back on.
(Please refer to the item 16 of motherboard lay-
out on chapter 1).
Warning:
1. Disconnect the power cable before adjusting the jumper settings.
2. Do not clear the CMOS while the system is turned on.
BIOS TBL Jumper: TBL_EN
The system cannot boot, if the BIOS failed to be
flashed in conventional flash BIOS process. You
will have no such worry when using the BIOS TBL
function, which is used to protect BIOS "Top Boot
Block". By using this function, the system still can
boot even if the flash BIOS fails and show some
information to recover the BIOS. To utilize this
function, you just short pin 2 and 3 with the jumper
cap (Please refer to the item 24 of motherboard
layout on chapter 1).
Chapter 2
955X7AA Series User Manual
Installation Instructions
Normal Status
(Default)
Clear CMOS
Clear CMOS Jumper
BIOS TBL
Enable
BIOS TBL
Disable
BIOS TBL Jumper
1
2
3
1
2
3
29