Using HOLD with MIN MAX or FAST MN MX
You can enable the HOLD mode when in the MIN MAX
mode is by pressing
No further minimum, maximum, or average updates occur
while the HOLD mode is enabled.
Exit HOLD mode by pressing
Using Relative Mode (REL)
Selecting Relative mode (
the display and store the present reading as a reference
for subsequent measurements.
Press
once to select the Relative Mode. (The
meter enters manual range when you enter the
Relative Mode.)
The reference appears in the secondary display. The
difference between the reference and a new
measurement appears in the primary display. See
Figure 2-8.
.
a second time.
) causes the meter to zero
Using Relative Mode (REL)
Press
a second time to enter the REL% mode
and display the difference as
reading.
In REL%,
% appears on the display.
Press
a third time to exit the Relative Mode.
Figure 2-8. Relative Mode
Getting Acquainted
2
10 % of the reference
tc039f.eps
2-21