Table of Contents
Advertisement
MAINTENANCE
AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 10 on page 9.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first remove the left shield cover.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
belt may need to be adjusted.
To adjust the belt, remove the left and right shield cov-
ers. Next, loosen, but de net remove, the M8 x 20ram
Bolt (23). Loosen the two M8 Locknuts (10), one on
each side of the Flywheel (37). Then, tighten the M6
Lecknuts (63), one on each side of the Flywheel, until
the belt is properly tightened. Finally, tighten the M8
Locknuts (10) and the M8 x 20mm Bolt (23). Then,
reattach the shield covers.
38
Next, turn the resistance knob to the lowest setting.
With the left shield cover removed, locate the Reed
Switch (43). Turn the Crank (21) until the Magnet (38)
is aligned with the Reed Switch. Loosen, but do not
remove, the M4 x 15mm Self-tapping Screw (47).
Slide the Reed Switch slightly closer to or away from
the Magnet, and then retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the left shield cover.
14
Hide quick links:
Advertisement
Table of Contents
