Weslo PURSUIT CT 3.8R User Manual page 9

9. 9
Attach the Handlebar (53) to the Upright (13)
with two M8 x 65mm Button Bolts (72), two M8
Curved Washers (46), and two M8 Locknuts (10).
53
72
10. The Console (16) requires four "AA" batteries
(not included); alkaline batteries are recom-
mended. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components. Remove the screw, remove the
battery cover, and insert the batteries into the
battery compartment. Make sure to orient the
batteries as shown by the diagram inside
the battery compartment. Then, reattach the
battery cover.
10
16
\
11. Tip: Avoid pinching the wires. While another
person holds the Console (16) near the Upright
(13), connect the console wire to the Extension
Wire (52). Then, insert the wires downward into
the Upright. Attach the Console to the Upright
with four M4 x 15mm Self-tapping Screws (47).
11
Avoid pinching
the wires during
this step
47
52
Wire
9