Weider 8510 User Manual page 10

14. Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8" x 2" Bolt (12) and
the 3/8" Nylon Locknut (21). (Note: This
Pulley is pre-assembled. It has been
shown disassembled for easy part identifi-
cation.) Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly,
15. Attach the Long Cable (23) to the Small "U"-
Bracket (67) with a 1/4" Nylon Locknut (2) and
a 1/4" Flat Washer (10). Do not completely
tighten the Nut. It should be threaded onto
the end of the Cable only a couple of
turns.
Attach the Small "U"-Bracket (67) to the
Weight Tube (63) with the 5/16" x 1 1/2" Bolt
(72) and a 5/16" Nylon Locknut (3).
16. Route the Short Cable (58) under the 3 1/2"
Pulley (15) attached to the lower hole in the
Press Frame (17). Be sure that the end of
the Cable with the ball is on the indicated
side of the Press Frame and that the Cable
is between the Pulley and the crossbar on
the Press Frame. Tighten the 3/8" Nylon
Locknut (21) and 3/8" x 3 3/4" Bolt (not shown).
Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). Be sure that the .Cable
Trap (not shown) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the
3/8" Nylon Locknut (21) and 3/8" x 3 3/4" Bolt
(not shown).
14 23
Bracket _. ,_._12
55
16
p.
72
63
s8
21
_Crossbar
42_
10