Assembly - Weider PRO 290 W User Manual

ASSEMBLY
To make assembly easier, carefully read the •
following assembly tips:
, Assembly requires two persons.
, Because of its weight and size. the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it,
, Place all parts }n a cleared area and remove the
packing materials Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The included grease and the fotfowing tools (not
included) may be required for assembly:
Two adjustable wrenches
One hammer
One standard screwdriver
One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches
To make assembly easier, read the assem_ :,;i'i
;bly. tips at the top of this page before you
assemble the weight bench_ !:::i:::':i' :i ::: _i:
Orienl the Crossbar (3) so that the warning decals
are on top..
Attach the Crossbar (3) to one of U_eUprights (!)
with two M8 x 55mm Bolts (18). two MB Washers
(I6), and two M8 Locknuls (17); do not tighten
the Locknuts yet.
Attach the Crossbar (3) to the other Upright (1)
in the same way,
t8
Warning 18
Deca_s
16
2_
Orient the Stabilizer (13) so that the indented
!_oles are _acing the floor°
Attach the Stabilizer (13) to the Front Leg (8) with
two M8 x 42mm Carriage Bolts (37) and two M8
Locknuts (17); do not tighten the Locknuts yet.
,\
Indents -'_
37._
_!7