Troy-Bilt STORM 8526 Operator's Manual page 19

ProbHem Cause Remedy
Ermine faiUsto start !. Chokenot in ON position. 1. Movechoketo ON position.
' 2. Sparkplugwire disconnected. 2. Connectwire to sparkplug.
3. Fueltank emptyor stale fuel. 3. Filltank with clean,fresh gasoline.
4. Enginenot primed. 4. Primeeng ne as instructedin
OperatingYourSnowThrower.
5. Fautyspark pug. 5. Clean adiustgap or replace.
6. Blockedfuel line. 6. Cleanfuel line.
7. Safetykey notin ignitionon engine. 7. insert keyfully intothe swtch.
1
Engine runs erratic
1. Unit runningon CHOKE. 1. Movechokeleverto OFF position.
2. Blockedfuel lineor stab fuel 2. Cleanfuel line;fill tank with clean,
fresh gasoline.
3. Wateror dirt in fuel system. 3. Drainfuel tank.Refill with
fresh fuel.
4. Carburetoroutof adiustment. 4. ContactTroy-BiltServiceCenter.
Eng ne overheats
1 CarburetornotadjustedproperY 1 1 ContactTroy-B t Servce Center
Excessive
1. Looseparts or damagedauger. 1. Stopengineimmediately and
Vibration
disconnectspark plug wire.Tighten
all bolts and nuts.If vibration
continues,haveunitservicedby a
Troy_Bilt S erviceCenter.
3. Exhaustport plugged.
Unit fails
to propel itself
1. Drivecontrolcable in needof adjust -
ment.
2. Drivebelt looseor damaged.
B
1. Adiust drivecontrolcable.Refer to
"MakingAdjustments".
2. Replacedrivebelt.
Removeobjectfrom augerwith
NOTE:This section
addresses minor
service issues. For
further details, contact
a Troy-Bilt authorized
service center or sail
1 (800) 520-5520 for
assistance.
19