Toshiba 55VX700U Owner's Manual page 18

Integrated high definition lcd television
Hide thumbs Also See for 55VX700U:
Table of Contents

Advertisement

Connecting remote IR devices
Usingthe IR OUTterminal
You can use the TV's IR OUT terminal
to remotely
operate
many
infrared
remote-controlled
devices
enclosed
in an entertainment
center
or similar
cabinet.
You will need:
• Dual-wand
IR blaster
cable (_¢' p. 14)
• Other cables
as required
to connect
the device(s)
to the
TV (_¢' p. 15, 16 and 17)
To set the IR OUT mode:
1 _
> PREFERENCES
> IR Control.
2
Press < or • to select Out.
To connect
the IR blaster
cable:
1
2
3
Locate the infrared
sensor
on the front
of your
device.
This sensor
is marked
on some devices.*
Align one of the IR blaster
cable's
wands
about
1
inch away from
the infrared
sensor
on the front
of
the device
and attach
it using
double-sided
mounting
tape. If you have a second
device,
attach
the second
wand
in a similar
manner.
Note: If you do not have a second device, coil the
second wand with a rubber band and leave it behind
the TV.
Plug the IR blaster
cable's
plug into the TV's IR OUT
terminal.
Front of IR-controlled DVD player (for example)
Front o f IR-controlled audio device(forexample)
Infrared
_,_'
"
_1_]
l
sensor
IR blaster cable wand
(approx.1 inch from device)
TVbackpanel
iN!otyr
m
Dual-
wand IR
blaster
cable
To control
the device(s):
Point either
the device's
remote
control
or the TV
remote
control
(that you previously
programmed
to
operate
the device;
_
Chapter
3) toward
the front
of
the TV and press
the button
for the desired
function.
The signal passes
from the remote
control
through
the
TV to the device
via the IR blaster
cable.
Note:
• To program the remote control to operate the device(s),
see "Programming
the remote to operate other devices"
(_ p, 85),
° The IR pass-through
feature does not support all IR-
controlled
devices. Satisfactory
quality may not be
attainable with certain devices.
*If you cannot
locate the device's
infrared
sensor:
1
Turn off the device.
2
Starting
at the device's
lower-left
corner,
place
the end of the device's
remote
control
(with the
infrared
emitter)
so it touches
the front
of the
device.
Press POWER.
(Do not use the TV's
remote
control
for this step.)
3
If the device
turns on, the sensor
is located
where
the remote
control
touched
the device.
4
If the device
does not turn on, move
the remote
control
slightly
to the right and press
POWER
again.
5
Repeat
the previous
steps if necessary.
18

Advertisement

Table of Contents
loading

This manual is also suitable for:

46vx700u

Table of Contents