Using The Hdmi Settings Feature; Setting The Hdmi Audio Mode - Toshiba 52ZV650U Owner's Manual

Using the HDMI settings feature
This menu consists of the following items (new
HDMI capabilities) and will be grayed out on non-
HDMI inputs.
Some HDMI legacy sources may not work properly
with your HDMI TV, please try setting the following
R°pti°ns (Deep Color, Lip Sy nc, INSTAPORT
TM,
and
GB Range) to Off. Adjusting these settings should
allow your HDMI legacy source to operate properly
with your TV.
° Deep Color: On
This feature allows the HDMI source to increase
available colors bits within the boundaries defined
by the RGB or YCbCr color space.
* Lip Sync: On
The Lip Sync feature allows an HDMI source such
as an audio receiver to adjust audio delay to match
the video processing delay of the TV.
• INSTAPORTrM: On
This feature reduces the lag of switching time when
switching HDMI sources.
• RGB Range: Auto
This feature adjusts RGB full range signal
automatically
When Limit is selected, RGB output signal is
output in the range from 16 to 235. When Full is
selected, RGB output signal is output in the range
from 0 to 255.
All of the above HDMI settings need proper HDMI
source devices. If an HDMI source device does not
support these features, the TV may not work
properly when these features are enabled.
Note: If your HDMI connection is capable of !080p and/or
your TV is capable of refresh rates greater than 60Hz or
supports Deep Color, you will need a High Speed HDMF M
cable. Conventional HDMI/DVI cables may not work
properly with this mode,
1
Select the appropriate HDMI input mode (HDMI
1, HDMI 2, HDMI 3, or HDMI 4).
2 From the SETUP menu, highlight AV
Connection
and press @.
3 Press • or • to select HDMI Settings.
Press • or • to highlight the item you want to
set.
5 Press • or _ to select your desired setting.
Setting the HDMI audio mode
To set the HDMI audio mode:
1
From the SETUP menu, highlight AV
Connection and press 3-
2 First press • or • to select PC/HDMI 1 Audio.
3 Press • or I_ to select HDMI 1 to make enable the
HDMI 1 Audio.
4 Continue to press press • or • to select HDMI 1
Audio.
5 Finally press • or _" to select Auto, Digital or
Analog. (Auto is the recommended mode.)
Mode Description
Auto
Digital
Analog
When viewing the HDMI i input, if
digital audio from the HDMI input is
available, it will be output. If not, the TV
will automatically detect and output
analog audio from the PC/HDMI 1
Audio input.
When viewing the HDMI 1 input, digital
audio from the HDMI input will be
output.
When viewing the HDMI 1 input,
analog audio from the PCiHDMI Audio
input will be output.
61