Displayingtv Status Information; Understanding The Auto Power Off Feature; Understanding The Last Mode Memoryfeature - Toshiba 52ZV650U Owner's Manual

DisplayingTV status information Understanding the auto poweroff
feature
To display TV status information using RECALL:
Press _ on the remote control.
The following information will display
(if applicable):
• Current input (ANT/CABLE, Video 1, etc.)
• If ANT/CABLE is the current in_,ut, either
"CABLE" (for cable TV) or "ANT' (for over-the-air
broadcasts).
• Channel number (if in ANT/CABLE mode)
• Input label (if set)
• Digital signal strength indicator (bar graph in
lower right corner of box; for ATSC signal only)
• Stereo, Mono or SAP audio status (when HDMI
input mode, Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
• GameTimer (if set)
The TV will automatically turn itself off after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast for
the day. This feature functions in ANT/CABLE mode
only.
Understanding the last mode
memoryfeature
If the power is cut off while you are viewing the
TV, the Last Mode Memory feature automatically
turns on the TV when the power is resupplied.
Note: If it is possible that you wi// be away from the TV for
an extended period of time, you should unplug the power
cord.
To close the RECALL screen:
Press _ again.
To display TV status information using INFO:
(only available
for ANT/CABLE
input)
Press _01 on the remote control.
The following additional information will display
for off air digital channels (if applicable):
• Title
• Duration
• Detailed description
To display Next information, press _ on the
remote control again. Pressing _ a third time will
remove the entire banner.
Note: The location of the banner can be moved to the top
or bottom of the screen by pressing • or • while the
RECALL or INFO display is on-screen. (The last position
will be stored to memory.)
62