Using The Hdmi Settings Feature - Toshiba Regza 32RV530U Owner's Manual

To set the REGZA-LINK Setup:
1
From the Setup menu, highlight REGZA-L1NK Setup
and press@.
2
Press.A. or T to highlight Enable REGZA-L1NK.
3 Press .... or ~ to select On.
Note: If you set Enable REGZA-L1NK to Off, the other
items will be grayed out.
4
Press.A. or T to highlight the REGZA-L1NK setup item
you want to use, and press .... or
~
to select On or desired
mode.
• TV Auto Input Switch: On/Off
• TV Auto Power: On/Off
• Oevice Auto Standby: On/Off
• Speaker Preference: TV Speakers/Audio Receiver
5
To save the new settings, highlight Done and press @.
To revert to the factory defaults, highlight Reset and
press@.
Using the HOMI settings feature
This menu consists of the following 2 items (new HOMI
capabilities) and will be grayed out on non-HOMI inputs.
Some HOMI legacy sources may not work properly with your
HOMI TV, please try setting the following options (Lip-Sync
Latency and Deep Color) to Off. Adjusting these settings
should allow your HOMI legacy source to operate properly
with your TV.
Note: You must disconnect your source device first before
settings can be adjusted.
• Lip-Sync Latency: On
This option activates an auto audio/video display timing
adjustment function that allows HOMI source devices to
accurately perform synchronization automatically.
• Deep Color: On (46" and 52" models only)
This feature allows the HOMI source to increase available
colors bits within the boundaries defined by the ROB or
YCbCr color space.
All above HOMI settings need proper HOMI source device.
If HOMI source products does not support these features,
the TV may not work properly by activating these features.
Note: If your HOMI connection is capable of 1080p and/or
your TV is capable of refresh rates greater than 60Hz or
supports Deep Color, you will need
a
Category 2 cable.
Conventional HOMI/OVI cables may not work properly with this
mode.
To set the HDMI Settings:
1
Select the appropriate HDMI input mode (HOMI I,
HOMI 2, HOMI 3, or HOMI 4).
2
From the Setup menu, highlight HDMI Settings and
press@.
3
Press .A. or T to highlight the item you want to set.
4
Press .... or ~ to select On or Off .
5
To save the new settings, highlight Done and press @.
To revert to the factory defaults, highlight Reset and
press@.
53
I