Replacing The Oven Light; Changing To The 24-Hour Clock Format; Maintenance - Thermador CM301 Care And Use Manual

Do-Tt-Yourself Maintenance
Do-It-Yourself
Replacing the Oven Light
NOTE: The Upper or Single Oven Light
must be replaced by a qualified ser-
vice technician.
CAUTIONS:
To prevent personal injury:
Before replacing the light bulb, be sure the
electric power is turned off at the circuit breaker,
Halogen bulbs get HOT INSTANTLY when
turned ON,
Be sure the oven and light bulb are cool,
Do not operate the oven unless the light cover
is securely in position,
\ J
CAUTION:
If the light cover is damaged or bro-
ken, do not use the oven until properly repaired.
The oven lights have a removable lens cover and a halo-
gen light bulb. The ceramic light socket housing is not
removable.
Built=in CH Oven Care and Use Manual
Naintenance
!0W HALOGEN
LAMP
\
Fixing
Clip
,Lens
Holder Clip
Housing
Ceramic Holder J
10. Place the fixing clip on the lens cover.
11. Slide the protective lens into the holder clip and push
the other end until the fixing clip snaps back into the
housing.
12. Turn on circuit breaker.
Replace bulb with a !2=Volt, !0=Watt Halogen bulb
only.
To replace Halogen Bulb:
1. Turn off circuit breaker.
2. Remove oven racks.
3. Slide the tip of a table knife blade between the fixing
clip and the glass lens cover.
5 Gently twist the knife blade to loosen the glass lens
cover. Catch lens cover with other hand as it loosens.
Set aside.
6. Remove the fixing clip.
7 Remove the bulb by grasping and sliding the bulb
straight up until the two prongs have cleared the
ceramic holder.
,
Do not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean
paper towel or facial tissue with the prongs facing
down. Place the two prongs in the ceramic holder,
pressing gently until the two prongs locate in the
ceramic socket.
9. Press down gently to seat the bulb.
Changing to the 24°Hour CLock Format
The oven has been preset to a !2= hour clock format.
To change the Time=of=Day Clock to a 24=Hour Clock,
follow these steps:
1. Turn off both ovens.
2. Touch START and hold the CLOCK pad at the same
time.
3. 12H appears in the Clock window; release both pads
at the same time.
4. Touch CLOCK and 24H replaces 12H. This alternates
when CLOCK is touched.
5. To complete the change, touch START.
53