Grizzly EXTREME G9860 Owner's Manual page 14

load dial
LOAD
Figure 6. 440V overload relay set at 7 amps.
4.
replace the control panel before connecting
the jointer to power.
Replacing control panel Light bulbs
1.
disCoNNECt JoiNtEr FroM poWEr!
2.
remove the control panel from the electrical
pedestal to access the rear of the power lamp
and oN button assemblies (see Figure 7).
Button assembly
lock latch
Figure 7. accessing the light bulb from the rear
of the control panel.
-12-
3.
use a small, flat screwdriver to move the
power lamp assembly lock latch to the left, as
shown in Figure 7, pull the assembly loose
from the panel, then replace the light bulb.
4.
re-install the lamp assembly, move the lock
latch to the right to secure it.
5. repeat Steps 3–4 for the oN button, then
re-install the control panel onto the electrical
pedestal.
Rewiring Motor
1. disCoNNECt JoiNtEr FroM poWEr!
2. remove the rear motor access panel, then
remove the motor wiring junction box cover.
3. Configure the terminal jumpers as shown in
Figure 8.
terminal
Jumper
Figure 8. illustration of motor wired for 440V
operation.
4. replace the motor junction box cover and
access panel before connecting the jointer to
power.
Extreme series Jointer (Mfg. since 9/11)