Auto Connecting - Samsung HMX-S10BN User Manual

w re networ!<
oonfaur t on
oonneoton
AUTO CONNECTING TO A NETWORK
You can connect to a network using an AP (access point) in the wireless network service area.
PRECHECK!
Select the record (_/1i_11) mode by pressing the MODE button, ",page 27
1, Touch the Network (_) tab _ "Settings" _ "Access Point Setting."
The camcorder automatically scans for available APs available in the network.
To reload the AP device list, touch the Refresh (_) tab.
2, In the list that appears, touch the desired AP.
The camcorder connects to the network if you are using an unsecured AP (an AP
without a Security Key or Pass Phrase).
If you select a WPS AP, touch the WPS PBC tab on the bottom of the LCD screen,
and then press the WPS button on the AP device or router within 2 minutes, which
will be activated on the screen.
If you select a secure AP, touch the ( ) tab and proceed to the next step.
3, Configure the network settings. See the Submenu items below.
. Authentication: Select an authentication type according to your AP's setting.
(Open, Shared, WPA-PSK, WPA2-PSK, WPA-PSKANPA2-PSK).
When you select Open or Shared, WPA is automatically set.
° Data Encryption: Select an encryption type according to your AP's setting.
(Disabled, WEP, TKIP, AES, TKIP/AES Mixed)
° Network Key: Enter the password using the keyboard that appears, and then touch the
(_) tab. For typing in characters using the virtual keyboard, see page 115.
• IP Setting: The default is Auto. To set the IP manually, refer to page 114.
4, Touch the (_) tab.
The camcorder connects to the network via the selected AP.
You can check the signal strength in the top right corner of the screen.