Clean Up & Storage - Eureka Atlantis Express 2550 Series Owner's Manual

EXPRESS CLEAN UP AND STORAGE
Before storing the portable deep cleaner for long periods of time, it is a good idea to set the shampoo/rinse selector
control to shampoo, remove the shampoo cartridge and squeeze the spray trigger for 10 seconds. This flushes the
shampoo residue from the system. Place cleaner on a surface where water can easily be cleaned up.
A. Emptying the Recovery Tank
CAUTION: Turn off the power switch and unplug the spot cleaner to
empty the recovery tank.
1. Pull straight up to remove the recovery tank from the unit.
2. Remove the cap (see illustration) and empty contents into a suitable water
drain.
3. Rinse out the waste water recovery tank thoroughly. Visually check to ensure
automatic shut-off (float) is operational and free of any lint. If not operational,
continue to rinse recovery tank.
4. Gently push the tank all the way into unit until secure.
5. Resume cleaning or store.
Automatic Shut-Off
The automatic suction shut-off functions when the waste water recovery tank has reached capacity. This can be detected by a
noticeable difference in the motor sound. Immediately turn off the unit when this happens and empty the recovery tank.
NOTE: The recovery tank fills to just below the drain cap.
B. Clean Suction Cover
CAUTION: Turn off the power switch and unplug the
electrical cord before cleaning.
1. Unsnap and tilt the suction cover forward. Suction cover does
not come off completely.
2. Rinse suction cover with water, removing dirt and lint.
3. Replace the suction cover by tilting it back and snapping it in
place.
C. Storing Hose and Cleaning Nozzle
1. Rinse out hose and cleaning nozzle with clean water before storing. Set the shampoo/rinse selector to shampoo, remove
the shampoo cartridge and squeeze the spray trigger for 10 seconds.
2. Remove cleaning nozzle from the hose and place in storage section between tanks.
3. Wrap hose around carry handle and snap back in place.
4. Place carry handle in down position.
NOTE: When removing cleaning nozzle from the hose, insure that both nozzle and hose are held above the unit
to drain excess water from hose.
Hose
Clean
Water Tank
6
Recovery Cleaning
Tank Nozzle
Hose
Connector
Carrying
Handle
Suction
Cover
Hose
Recovery
Tank
Empty
Cap