How To Assemble Your Vacuum Cleaner; Installing Clean Water Tank - Eureka NEW500 Series Owner's Manual

Insert end of handle into
the top of main body.
Locate the hole on the
back of the main body.

Installing Clean Water Tank

Use warm water and Eureka cleaning solution. Always use Eureka cleaning solution in your machine, other cleaning
solutions may damage the machine and void the warranty.
Do not use water warmer than 140 degrees Fahrenheit. Do not use boiling water or heat water or tank in microwave.
6
Eureka Customer Service HELPLINE 1-800-282-2886
Use screwdriver
to secure into
place
Use screwdriver to secure
into place.
To install the clean water tank, align it with the opening and press
down vertically until it clicks into place.
To remove the clean water
tank, hold the machine
body with one hand, and
grab the clean water tank
with the other hand and
pull it up and out vertically.
Open the lid of clean
water tank and fill it with
tap water. If deep clean-
ing is required, just pour
the cleaning solution into
the water tank again
according to the specified
proportion.