Easy Assembly, And How To Use Storage Base - Eureka NEC510 Series Owner's Manual

Easy assembly
1
. Slide wand onto hand vacuum
until it clicks (Fig. 1).
2
. Push wand into motorized floor
nozzle until it clicks (Fig. 2).
How to use storage base
1. Insert storage base shaft into slot
on base until it clicks into place.
Ensure side of shaft that says
Floor Nozzle goes in the same
side as wheel well.
2. Detach hand vacuum from wand
3. Keep wand attached to floor
nozzle and place in the wheel well
rest on storage base
4. On back of hand vacuum, slightly
below the vent, locate the notch
5. On upright portion of storage base
locate the hook
6. Align notch on hand vacuum so it
rests on storage base hook
7. Wrap power cord either around
the cord wrap hooks on the wand
or around the hand vacuum.
8. Tools can be stored on the two
side mounts
Note: When lifting unit on storage
base always make sure hooks are
properly engaged with both the wand
and the hand vacuum
6
Eureka Customer Service HELPLINE 1-800-282-2886
1
Click!
2
Click!
3
Tool base assembly
Click!
4