Power Management Setup - ECS G31T-M9 Manual

Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
ACPI Suspend Type
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume By RING
Resume By PCI/PCI-E/Lan PME
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resume on RTC Alarm
: Move
F1: General Help
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
Soft-Off by PWR-BTTN (Delay 4 Sec)
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake Up Alarms. This item lets you install a software power down that is con-
trolled by the power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay 4 Sec, then
you have to hold the power button down for four seconds to cause a software power
down.
Power Management Setup
S3
Delay 4 Sec
Power Off
Disabled
Disabled
Disabled
Disabled
Disabled
Enter : Select +/-/: Value
F10: Save ESC: Exit
F9: Load Default Settings
Using BIOS
Help Item
Select the ACPI
state used for
System Suspend.
35