Power Management Setup - ECS GF8200A Manual

OnBoard AUDIO Function (Enabled)
Use this item to enable or disable the onboard Audio function.
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
OnBoard IR (Disabled)
Use this item to enable or disable the onboard infrared port, and to assign a port
address.
USB Controller (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
ACPI Suspend Type
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume by RING
Resume By PCI/PCI-E/Lan PME
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resume by USB (S3)
Resume on RTC Alarm
: Move Enter : Select
< >
F1: General Help
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
Power Management Setup
S3
Instant Off
Power Off
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
+/-/: Value F10: Save ESC: Exit
F9: Load Default settings
Using BIOS
Help Item
Select the ACPI
state used for
System Suspend.
37