Advanced Setup - ECS GF8200A Manual

Table of Contents

Advertisement

Advanced Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
HT Frequency Auto
AMD C&Q
Quick Power on Self Test
Boot Up Numlock Status
LOGO Display
APIC Mode
*1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Removable Drives
Boot Other Device
: Move
Enter : Select
< >
F1: General Help
HT Frequency Auto (Anto)
This item enables users to manually set up the HyperTransport frequency, ranging
from Auto, 1x, to 5x.
AMD C&Q (Enabled)
This item helps the system to lower the frequency when CPU idles. When the
frequency decreases, the temperature will drop automatically as well.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Boot Up Numlock Status (ON)
This item defines if the keyboard Num Lock key is active when your system is
started.
LOGO Display (Enabled)
Enables or disables the display of the special logo of Black Series during boot.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
1st/2nd/3rd Boot Device (Hard Drive/CD/DVD/1st FLOPPY DRIVE)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
Advanced Setup
Auto
Enabled
HT frequency selection
Enabled
by CPU capability and
ON
SouthBridge to CPU
Enabled
frequency selection
Enabled
Hard Drive
CD/DVD
1st FLOPPY DRIVE
Press Enter
Press Enter
Yes
+/-/: Value
F10: Save ESC: Exit
F9: Load Default settings
Using BIOS
33
Help Item

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents