Table of Contents
Advertisement
Thechannel memory is thelist ofTV
Channel numbers y ourTV will stop
onwhenyoupress the
CHAN up or
down button.
You can program
any
list of channels
into the channel
memory.
The quickest way to program your
channel memory
is to use the
A UTOPROGRAM
function.
If you
use the A UTOPROGRAM
function,
your TV wi!l automatically
cycle.
through all channels
and place active
chaimels
into the channel memory.
First follow the instructions
to
auto,program
channels,
and then add
or e:case individual
channels
as
desired.
1.
AutoProgramming
Channels
into Channel Memory
--(with
or without
remote)
1. Connect home antenna(s) or cable-
TV to your set,
2. After you have turned on the TV
and adjusted the volume, repeatedly
press MENU to select SETUP
MENU, and then press + or - to
display the setup functions.
Repeatedly press MENU to select
the A UTOPROGRAM function.
3. Press either + or- to begin
autoprogramming.
The TV will first
program all channels for ANTA
input and then program all channels
for ANT B input (even if you only
have one antenna input connected).
4; When the TV is finished cycling,
you can check to see which channels
are in memory by pressing the
CHAN up or down button.
Notes:
• The AutoProgram feature will place into
memory active TV channels that have a
va_[id.signalat the time you autoprogram
your TV.
• Art active channel may be missed
occasionally if its signal is very weak or if
the channel happens to be "off the air"
when the TV is autoprograrnmed.
• Art inactive channel may be included in the
channel memory if there happens to be
sonae sort of "noise" or "stray signal" on
the channel when the TV is
autoprogrammed.
• Signals from other components connected
to the INPUT jacks can not be
autoprogrammed.
Channel 91 (which
accesses INPUT 1 jacks) was added to the
channel memory at the factory and will
remain in the channel memory until you
erase it. Channel 92 (INPUT2) and
Channel 90 (S-VIDEO connector) can be
added to channel memory if desired.
• Ordy channels 1-99 can be stored in
channel memory.
2.
Erasing/Adding
Channels in Channel Memory
(with or without
remote).
1. To erase or add a channel,
repeatedly press MENU to select
SETUP MENU, and then press + or
- to display the setup functions.
Repeatedly press MENU to select
CHAN MEM function.
2_
Then select the desired channel
number by pressing CHAN up or
down (or the two corresponding
number buttons on the remote).
3. Press + to add the channel to
memory, or press - to erase the
channel from memory.
3.
Adding Video Input Channels to Channel
Memory
-- (with remote)
If you have a video device Connected to
the S-VIDEO or INPUT jacks on the
back of the TV, you can view its signal
either by directly selecting channel 90
(for S-VIDEO connector), channel 91
(for INPUT 1 jacks), or channel 92 (for
INPUT 2 jacks) with the number buttons
on theremote or by adding those
channels to the channel memory.
Adding channels 90, 91, and 92 to
channel memory allows access to the
video inputs at the TVby pressing the
CHAN up and down buttons as well as
by using the remote control.
22
Advertisement
Table of Contents
