Auto Programming - RCA IB-X20162GS Owner's Manual

Button
The Channel Memory is the list of
channel numbers your TV will stop
on when you press the CHANNEL A
or V button. You can program any
list of channels into the Channel
Memory.
Your TV is so automatic that you will
probably never need to manually
operate this feature.
The first time you turn on your TV, it
will automatically cycle through all
channels and place active channels
into the Channel Memory. You can
then add or erase channels as desired
by following the instructions on the
next page.
1.
AutoProgramming Channels into Channel Memory
|. Connect home antenna(s) or 3.
cable-TV to your set.
2,
After you have turned on the
TV and adjusted the volume,
repeatedly press the SETUP
button until the AutoProgram
display appears on the screen.
SETUP
E
AUTOPROGR_M PUSH +
Press either "-" or "'+" to
begin programming. The TV
will cycle thru available
channels in your area and
place active channels into
memory. If all available
channels are of reasonable
signal strength and you prefer
not to add or erase any
channels from memory,
programming is complete.
AUTOPROGRAHMING
S7
4. When the TV is finished
cycling, you can check to see
what channels are in memory
by pressing the CHANNEL A
or V button. Your set will
stop on each of the channels
in memory.
Notes:
• Make sure the outlet you plug your TV into is "on" al! the time (not
on a wall switch) to prevent the TV from losing its channel memory.
• if there is an extended power failure, your TV will automatically
reprogram active channels the first time you turn it on after the power
failure.
16