Mitsubishi HS-U780 Owner's Manual page 58

Chapter 3: Operating YourVCR _ Recordil_
CH DAY ON OFF
2 MOI7 ll:30a I:30PSP
lO TH20 9:00pIO:OOpEP
..... : : SP
: : SP
Use ADJUST _6 Sele6i;_
:
and ENTER :
Press MENU for Main Menu
Recap Screen
O You will see the "recap" screen. Use the ADJUST dial to place
the cursor next to the program you wish to cancel.
O Press the CANCEL button. The prograra is erased.
O Press the MENU button once to return to the '_v'CR Main
Menu"; press it again to tu_rn off' the menus.
usingtheTIMERRESET button
You can use the TIMER RESET button on the rear panel to erase
both the time and all programmed recordings.
To use the TIMER RESET button, press it with a pencil or a ball
point pen. The power will turn off and the clock will be cleared.
All programmed recording is erased. Howevel:, if you have set the
"Clock set" setting of the "Set the clock" menu to AUTO, the auto
clock function will automatically set the clock again.(See 1c,age 37.)
loadinga tapefor programming
If, after programming, you forget to load a tape, or if you load a
tape with its erasure tab removed, then the Frrogrammed record-
ing light and the tape status symbol will flash. A tape withoul_ an
erasure tab will be ejected. To correct this, load a tape with its
erasure tab intact, and turn off the VCR.
usingthesatellitereceiver
If you are using an RCA or a Sony satellite receiver, your VCR
can automatically turn the receiver on and off when it is time for
a programmed recording. However, if you are using a
PRIMESTAR ® receiver, you will have to t_trn the receiver on
before the programmed recording begins.
Before turning off the VCR to put your VCR in stand-by fi)r
recording, make sure that the satellite receiver's menu turns off.
You can view satellite channels through your VCR when your
VCR is off only if you connected your VCR and TV with an
S-Video cable. (Howe:ver, if the VCR is off and when the auto
clock function works to set the clock, you cannot view satellite
channels.) If you used a standard video cable, you can only view
satellite channels through your VCR when the VCR is on
memory backup
If the VCR is without power fi)r 30 minutes or less, it will retain
the clock and the programmed settings, provided the VCR has
been plugged in for at least an hour beforehand. If the power is
lost for more than 30 minutes, the clock and the programmed
settings will be lost. However, if you have set the "Clock set"
setting of the "Set the clock" menu to AUTO, the auto clock
function will automatically set the clock again. (See page 37.1
58