Advertisement
Available languages
Available languages
Care & Cleanin
Cleaning
Procedures
* Brand names are registered
trademarks
of the
respective
manufacturers.
** To order call 1-877-232-6771
USA or
1-800-688-8408
Canada.
Broiler Pan
and Insert
Sealed Gas
Burners
Burner Grates
Clock and
Control Pad
Area
Control
Knobs
Cooktop and
Control Panel -
Porcelain Enamel
Side Panels,
Storage Drawer,
Lower Broiler
Door (select
models} and
Door Handles -
Painted Enamel
Never cover insert with aluminum foil as this prevents the fat from draining to the pan below.
• Place soapy cloth over insert and pan; let soak to loosen soil.
• Wash in warm soapy water. Use scouring
pad to remove stubborn
soil.
• Broiler pan and insert can be cleaned in dishwashe_
• Clean frequently
Allow burner to cool Clean with soap and plastic scouring pad. For stubborn
soils, use
a non-abrasive
cleaner and a cloth. Try to prevent the cleaner from seeping into the gas ports as this will
affect the flame. If the cleaner does enterthe
ports, clean with a soft bristle brush or a straight pin especially
the port below the ignitor. Do not enlarge or distort holes.
• Be careful not to get water into burner ports.
• Use care when cleaning the ignitor. If the ignitor is wet or damaged
the surface burner will not light.
• Wash grates with warm, soapy water and a nonabrasive,
plastic scrubbing
pad. For stubborn soils, clean
with a soap-filled,
nonabrasive
pad or a sponge and Cooktop Cleaning
Creme (Part #20000001).**
• For burned on soils, remove grates, place on newspapers
and carefully spray with commercial
oven
cleaner.
(Do not spray surrounding
surfaces.)
Place in plastic bags for several hours or overnight.
Wearing
rubber gloves, remove from bags. Wash, rinse, dry and replace on cooktop.
• To activate
"Control Lock" for cleaning,
see page 11.
• Wipe with a damp cloth and dry. Do not use abrasive cleaning
agents as they may scratch the finish.
• Glass cleaners may be used if sprayed on a cloth first. DO NOTspray
directly
on contml pad and
display area.
• Remove knobs in the OFF position
by pulling forward.
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
• Turn on each burner to be sure the knobs have been correctly
replaced.
Porcelain enamel isglass fused on metal and may crackorchip
with misuse It is acid resistant, not acid proof.
All spillovers, especially
acidic or sugary spillovers, should
be wiped up immediately
with a dry cloth.
• When cool, wash with soapy water, rinse and dry.
• Never wipe off a warm or hot surface with a damp cloth. This may cause cracking
or chipping.
• Never use oven cleaners, abrasive or caustic cleaning
agents on exterior finish of range.
• When cool, wash with warm soapy water, rinse and dry. Never wipe a warm or hot surface with a damp
cloth as this may damage the surface and may cause a steam burn.
• For stubborn soil, use mildly abrasive cleaning agents such as baking soda paste or Bon Ami*. Do not use
abrasive cleaners such as steel wool pads or oven cleaners. These products will scratch or permanently
damage the surface.
Note:
Use a dry towel or cloth to wipe up spills, especially
acidic or sugary spills. Surface
may
discolor
or dull ff soil is not immediately
removed.
This is especially
important
for white surfaces.
21
Advertisement
