Maytag MVWC450XW1 Use And Care Manual page 13

TROU BLESH OOT[ NG
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) "N
to possibly avoid the cost of a service ca[[...In U.S.A. htt)://www.maytag.com/he[p - In Canada www.maytag.ca
Washer won't run or fill,
washer stops working
Check for proper water supply.
Check proper electdca[ supply.
Normal washer operation.
Washer may be tightly packed.
Not using HE detergent or using too
much HE detergent.
Solution
Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hosesp which can restrict water flow.
Plug power cord into a grounded 2. prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take 2 to
3 minutes before water is added.
Remove several items, rearrange load evenly in basket and add
detergent. Close lid and press START/Pause/Unlock.
Do not add more than 1 or 2 additional items after cycle has started
to avoid tightly packing or unbalancing.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select RINSE & SPIN. Press STAR]-/
PauseTUnlock. Do not add more detergent. J
13