Built-In Auto Light (Using The Light, Replacing The Bulb) - Panasonic Palmcorder PalmSight PV-L681 Operating Instructions Manual

Built-in Auto Light
For recording in dim lighting.
Note:
• Using Light reduces battery operating time.
• Provide proper ventilation when using
Light extensively in a hot environment.
• Using Light when the Camcorder is
powered by a car battery may shorten bulb
life.
• Set Light to OFF when not in use.
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA,
Set LIGHT to AUTO.
Light turns on/off automatically according
to lighting conditions.
Or, set LIGHT to ON/OFF manually.
-_o_E "_J--_lf_ appears in EVF or
| _""_ LCD monitor when
Light is on.
I Lcauti°n: )
ight becomes hot. Never cover Light
hile on.
4
3
Before you begin...
• Order Part No. VULS0001 (VLLWO015and
cushions) for replacement bulb unit.
• Set POWER to OFF.
Press in on both sides of lens cover
and pull straight out and off.
Using Tweezers or needle-nose
pliers, carefully remove bulb.
• Take unit to service center if you need
assistance.
Replace bulb using a clean cloth or
tissue. (Do not touch with fingers.)
Replace lens cover.
Note:
• Handle bulb gently. Excessive force may
cause bulb to crack.
i DANGER: ]
se only replacement bulb (PART NO. VLLW0015) supplied by Panasonic to reduce
isk of fire.
andle new bulb with cloth or tissue as skin oils will decrease bulb life.
emove lens cover and allow bulb to cool before replacing to avoid possible burn
azard.
15