Panasonic Palmcorder PalmSight PV-L681 Operating Instructions Manual page 21

Playing Back Recordings
Connect Camcorder to a TV to view
playback or recordings in progress.
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
'C°nnect°ns 1,,eOW to
TV VCR "-, view playback.
_ _ lil !1 _ CAMERA "-_ view picture as it is recorded.
o ov,eo un vo an, se
See TV owner's manual.
Video Out _Audio/Video Cable 3 Begin playback or recording.
(Supplied)
I CATV System Installer I
This reminder is provided to call the CATV system installer's attention to Article 820-40 I
of the NEC in USA (and to the Canadian Electrical Code in Canada) that provides I
guidelines for proper grounding and, in particular, specifies that the cable ground shall I
be connected to the grounding system of the building, as close to the point of cable I
entry as practical. J
|vL*,]; i "] IT_P'J _ ._1 ! _.-.] t_ -,J I_'TJ :,1_:"t ;-a
1
_Load Battery in PlayPak _
2
Remove Battery lid
and insert AA
battery.
• Do not reverse
polarity.
• Replace battery
when tape loading/unloading takes
longer than usual.
(Remove [_ Cassette
Clnsert _ Cassette in PlayPak
_b
Slide RELEASE to
open cassette lid.
C Insert the
cassette with the
window up and on the
left, then snap lid shut.
_a
, Do not obstructcassette reel while loading.
Slide RELEASE
and wait for lid to • Allow PlayPak Load Detector to fully retractbefore
open. using in VHS VCR+
us ca--
out through
hole in bottom of
PlayPak with Load Detector
your finger.
Turn _ cassette
Wheel in
direction of arrow to
take up any slack.
21