Panasonic Palmcorder PalmSight PV-L681 Operating Instructions Manual page 10

Supplying Power
Caution:
• Charge only withspecified charger.
• Battery can be charged within a temperature range of
t0 °C (50 °F) and 35 °C (95 °F).
• Battery is normally warm after charging or just alter use.
• Do no{use an insufficiently charged or_om-out Battery.
Safety precautions:
• Do not get Battery near, or dispose of in fire.
• Do not directly connect (short circuit) the positive (+) and
negative (-) terminals.
• Never attempt to disassemble or reassemble
Battery.
U.S.A. CONSUMERS: ATTENTION:
The product you have purchased is powered by a nickel cadmium battery
which is recyclable. At the end of its useful life, under various state and local
17_ laws it is illegal to dispose of this battery into your municipal waste stream.
[_ Pleasecall 1-800-8-BATTERY for information on howto recycethsbattery.
To avoid Battery damage:
• Do not drop or jar Battery.
• Use Battery with specified units only.
• If Battery is used in extremely high
temperatures, a safety device will
automatically prevent operation,
To prolong Battery life:
• While not in use, remove Battery
from the Camcorder and AC Adaptor
and store in a cool, dark, dry place.
• Keep Battery terminals clean.
I
DC rower Cable
_PowER Lamp _--_
/
Connector
Connect AC Adaptor VCR DC OUT to
Camcorder DC IN with supplied DC
Power Cable.
Plug in AC Adaptor.
POWER Lamp lights.
Note:
• While the DC Power Cable (supplied) is
connected to the AC Adaptor, the Battery
cannot be charged.
• When not in use, unplug AC Adaptor from
AC outlet. (Adaptor uses 1.2 W of electricity
while plugged in.)
• CAUTION:
This unit will operateon 110/120/220/240 V AC.
An AC plug adaptormay be requiredfor voltages
other than 120 V AC. Pleasecontacteither a
localor foreign electrical partsdistributor for
assistancein selecting an alternate AC plug.We
recommendusingthe accessorypowerplug
adaptor(VJSS0070) in an area whichhas
,special AC outlets.
10
i Cigarette Lighter
Socket (12 V)
:!
== Car Battery Cord Cigarette
• (optional) Lighter Plug
il
Connect PV-C16 Car Batterv Cord
(optional) to Camcorder DC IN.
i 2 _) Start engine first.
• _) Plug Car Battery Cord into
• Cigarette lighter socket.
• • If Car Battery cord fuse needs
• replacing, use exact current rating
• (in amps).
== Note:
• • This cord only works in vehicles
• equipped with DC 12 V (negative
ground) battery. Check with your car/
=- truck dealer. Use only specified car
• battery cord.
• • To avoid blowing the car battery cord
• fuse, do step 2 in the proper order.
• • Running vehicles must be well ventilated.
• • When not in use, disconnect cigarette
, • hghter plug.