Using The Control Program - Extron electronics ISS 408 User Manual

Switcher Software, cont'd

Using the control program

Many items found in the ISS/ISM Control Program are also accessible via front
panel controls and the LCD menus, see chapter 3, "Operation", and under SIS
control, see chapter 4, "Programmer's Guide". The ISS/ISM Help Program
provides information on settings and on how to use the control program itself.
1.
Figure 5-3 — Comm port selection window
2.
3.
Figure 5-4 — Address and password entry
4.
5-4 ISS 408 Integration Seamless Switcher • Switcher Software
To run the control program, click Start > Programs >
Extron Electronics > ISSISM. The Comm menu appears on the
screen (figure 5-3).
Select the comm port that is connected to the ISS's Remote port or select
IP [LAN] and click OK.
If you selected a comm port, proceed to step 5.
If you selected IP [LAN], proceed to step 3.
If you selected IP [LAN] in step 2, the IP connection window appears
(figure 5-4). The window displays the last IP address that this computer was
logged on to via the ISS/ISM Control Program. If no one has logged on to the
ISS from this computer, enter the ISS IP address. If the address has not been
changed, the factory-specified default is 192.168.254.254.
If you selected IP [LAN] in step 2, when prompted, enter the appropriate
administrator or user password and click Connect.
If you logged on using the administrator password, the program connects you
to the ISS with all of the administrator rights and privileges.
If you logged on using the user password, the program connects you to the
ISS with only user capabilities.
If an incorrect password was entered, the program beeps and returns to the
password entry display.