NordicTrack COMMERCIAL 1750 User Manual page 16

HOW TO TURN ON THE POWER HOW TO USE THE MANUAL MODE
iMPORTANT: if the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power, if you do not
do this, you may damage the console displays or
other electrical components.
.
Plug in the power cord
(see page 14). Next, lo-
cate the power switch on
the treadmill frame near
the power cord. Make
sure that the switch is in
the reset position.
Reset_
iMPORTANT: The console features a display
demo mode, designed to be used if the tread-
mill is displayed in a store, if the demo mode is
turned on, the displays show a preset presenta-
tion after you plug in the power cord and press
the power switch into the reset position, before
you insert the key. To turn off the demo mode,
see step 5 on page 24.
.
Next, stand on the
walking platform of
the treadmill.
Locate the clip at-
tached to the key,
and slide the clip
securely onto the
waistband of your
clothes. Then, in-
sert the key into the console. After a moment, the
displays will light. IMPORTANT: In an emergency,
the key can be pulled from the console, caus-
ing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if
the key is not pulled from the console, adjust
the position of the clip.
3. Before using the treadmill, please check for
firmware updates (see step 8 on page 26).
Note: The console may be able to display speed and
distance in either miles or kilometers. To find which
unit of measurement is selected, see step 4 on page
24. For simplicity, all instructions in this manual refer to
miles.
1. Insert the key into the console.
See HOW TO TURN ON THE POWER at the left.
If necessary, press the Incline buttons to adjust the
incline level to 0 percent. Note: it may take a
minute for the console to be ready for use.
2. Select the main menu.
Each time the key is in-
serted, the main menu
will appear.
If the iFit Iogin screen appears, press the Main
Menu button and then press the Back button to re-
turn to the main menu.
If you have selected a workout or the iFit Live
mode, press the iFit Menu button in the upper right
corner of the screen. Next, press the End Workout
button and then press the Done button to return to
the main menu.
Note: A Demo button may appear in the lower left
corner of the screen. If you press the Demo button,
the treadmill will run a preset presentation.
3. Start the walking belt and adjust the speed.
To start the walking belt, press the Start button on
the screen or the Start button on the console. The
walking belt will begin to move at 1 mph. As you
exercise, change the speed of the walking belt as
desired by pressing the Speed increase and de-
crease buttons. Each time you press one of the
buttons, the speed setting will change by 0.1 mph;
if you hold down the button, the speed setting will
change in increments of 0.5 mph.
16