Removing The Battery - Dell Studio One 19 Service Manual

Back to Contents Page
Battery
Dell Studio One 19/1909 Service Manual
Removing the Battery
Replacing the Battery
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
Removing the Battery
1. Record all the screens in system setup (see
2. Follow the procedures in Before You
3. Remove the computer cover (see
4. Remove the shield (see Removing the
5. Disconnect the cables to the connectors HDD_POWER and SATA_1 (see
6. Locate the battery socket on the system board (see
CAUTION: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the
object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by
prying off the socket or by breaking circuit traces on the system board.
7. Carefully press the battery release lever away from the battery and the battery will pop out.
8. Remove the battery from the system and properly dispose of the battery.
1 coin-cell battery
System Setup) so that you can restore the correct settings in
Begin.
Removing the Computer Cover).
Shield).
System Board
2 battery socket
System Board Components).
Components).
step 7.