Replacing The Hard Drive; Removing The Optical Drive - Dell Studio One 19 Service Manual

1 hard drive
3 hard drive carrier
Replacing the Hard Drive
1. Follow the procedures in Before You
2. Prepare the new hard drive for installation and check the documentation that accompanied the drive to verify that the drive is configured for your
computer.
3. Align the screws holes on the hard drive with the screw holes on the hard drive carrier.
4. Replace the four screws that secure the hard drive to the hard drive carrier.
5. Reconnect the hard drive connector to the hard drive.
6. Slide the hard drive carrier into the grooves in the chassis.
7. Align the screw holes on the hard drive carrier with the screw holes on the chassis.
8. Tighten the two captive screws that secures the hard drive carrier to the chassis.
9. Replace the shield (see Replacing the
10. Replace the computer cover (see
Removing the Optical Drive
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the shield (see Removing the
4. Remove the stand (see Removing the
5. Remove the back I/O panel (see
6. Remove the processor fan (see
7. Remove the right speaker (see
8. Disconnect the optical drive connector.
NOTE: If you are not replacing the optical drive at this time, disconnect the other end of the data cable (SATA_2) and power cable (ODD_POWER)
from the system board and set it aside.
9. Remove the three screws securing the optical drive carrier to the chassis and slide the optical drive carrier out of the computer.
2 screws (4)
Begin.
Shield).
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Shield).
Stand).
Removing the Back I/O Panel).
Removing the Processor Fan).
Removing the Right Speaker).