Clearing Cmos Settings - Dell Studio One 19 Service Manual

6. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
7. Wait for approximately five seconds to clear the password setting.
8. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
9. Replace the stand (see Replacing the
10. Replace the shield (see Replacing the
11. Replace the computer cover (see
12. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
WARNING: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
WARNING: The computer must be disconnected from the electrical outlet to clear the CMOS setting.
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Removing the shield (see Removing the
4. Remove the stand (see Removing the
5. Remove the back I/O panel (see
6. Locate the 3-pin CMOS connector (CLR_CMOS) on the system board (see
Stand).
Shield).
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Shield).
Stand).
Removing the Back I/O Panel).
System Board Components).