2. To replace the speaker, route the speaker cables back into position.
3. Connect the right speaker cable to the connector (SPEAKER_2) on the system board.
4. Place the speaker in position and replace the four screws that secure the speaker to the chassis.
5. Replace the processor fan and heat sink (see
6. Replace the stand (see
Replacing the
7. Replace the shield (see
Replacing the
8. Replace the computer cover (see
9. Connect your computer and all attached devices to electrical outlets, and turn them on.
Removing the Left Speaker
NOTE:
To locate the left speaker, see
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove the shield (see
Removing the
4. Remove the four screws that secure the speaker to the chassis.
NOTE:
Make a note of the cable routing before you dislodge the cable.
5. Disconnect the left speaker cable from the connector (SPEAKER_1) on the system board.
1
screws (4)
6. Lift the speaker away from the system board.
Replacing the Left Speaker
1. Follow the procedures in
Before You
2. To replace the speaker, route the cables back into position.
Replacing the Heat Sink
Stand).
Shield).
Replacing the Computer
Cover).
Inside View of Your Studio
Begin.
Removing the Computer
Cover).
Shield).
2
speaker cable
Begin.
and
Replacing the Processor
One.
Fan).