Dell Inspiron One 19 Touch Service Manual page 38

1 cutouts (2)
3 notch
3. Insert the memory module into the connector until the memory module snaps into position.
If you insert the memory module correctly, the securing clips snap into the cutouts at each end of the memory module.
1 cutouts (2) 2 securing clip (snapped in position)
4. Replace the system-board shield (see
5. Replace the inverter (see Replacing the
6. Replace the I/O bracket (see
7. Replace the back cover (see
8. Replace the display bezel (see
9. Replace the speaker cover (see
10. Replace the decorative cover (see
11. Replace the optical drive (see
12. Replace the computer stand (see
13. Replace the I/O cover (see Replacing the I/O
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
14. Connect your computer and all attached devices to electrical outlets, and then turn them on.
15. When the message appears stating that memory size has changed, press <F1> to continue.
16. Log on to your computer.
17. To verify that the memory is installed correctly, click Start button
18. Check the amount of memory (RAM) listed.
Back to Contents Page
2 tab
4 memory module
Replacing the System-Board
Inverter).
Replacing the I/O Bracket).
Replacing the Back Cover).
Replacing the Display Bezel).
Replacing the Speaker Cover).
Replacing the Decorative Cover).
Replacing the Optical Drive).
Replacing the Computer Stand).
Cover).
Shield).
® Control Panel® System.