Table of Contents
Advertisement
Chapter 2: Connecting YourVCR
VHI- Antenna
UHI- Antenna
A
_ ii 00_ h::_txi_Wi:a
Lbi_d
_300
Ohm Flat Twin Lead
300-75 Ohm Adapter
Combiner
Connecting theTelevision
Now that you have completed
the antenna
connections
to your
VCR, you're ready to connect
the VCR to the TV. (If you haven't
connected
the antenna
to the VCR, go to page 10, "Connecting
the
Antenna
or Cable to the VCR.") Because
every television
is
different
(especially
older model TVs), your VCR may need to be
connected
in one of a variety
of ways. This section
shows you:
• Determining
if you need a splitter,
•
Connecting
an older TV to the VCR, and
• Connecting
a TV with audio and video inputs.
Determiningif you needa splitter
You should look at the back panel
of your TV to see if you need
any special equipment
to connect
the TV to the VCR. You may
need an attachment
called a UHF/VHF
splitter
(which is avail-
able at your local electronics
store). The chart below will tell you
if you need a splitter,
and what the splitter
will look like.
If the TV's antenna terminal
looks like this,..
®
ANTENNA
IN
©O
UHF
®
VHF
©©
UHF
©O
VHF
... then you will need splitter that looks like this,
No splitter needed
From ANTENNA
OUT on VCR
on TV
From ANTENNA
OUT on VCR
on TV
14
/16
Advertisement
Table of Contents
