Assembling Your Stand Mixer - KitchenAid KSM7990WH0 Instructions Manual

Assembling Your BowJ Lift Stand Mixer
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire or electrical shock.
To Attach Bowl
I. Turn speed control to OFE
2. Unplug Stand Mixer or disconnect power.
3. Place bowl lift lever in down position.
4. Fit bowl supports over locating pins.
S. Press down on back of bowl until
bowl pin snaps into spring latch.
6. Raise bowl before mixing.
7. Plug into a grounded 3 prong outlet
or reconnect
power.
To Remove Bowl
I. Turn speed control to OFE
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl lift lever in down position
4. Remove flat beater, wire whip, or
dough hook.
S. Grasp bowl handle and lift straight
up and off locating pins.
To Raise Bowl
I. Rotate lever to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.
To Lower Bowl
I. Rotate lever back and down.
To Attach Flat Beater, Wire Whip,
or Dough Hook
I. Turn speed control to OFE
2. Unplug Stand Mixer or disconnect
power.
3. Slip flat beater
on beater shaft
and press upward
as far as possible.
4. Turn beater to right, hooking beater
over the pin on shaft.
S. Plug into a grounded 3 prong outlet
or reconnect power.
To Remove Flat Beater, Wire Whip,
or Dough Hook
I. Turn speed control to OFE
2. Unplug Stand Mixer or disconnect
power.
3. Press beater upward as far as
possible and turn left.
4. Pull beater from beater shaft.
S. Plug into a grounded 3 prong outlet
or reconnect power.
Commercial Stand Mixer SPEED
Control and Lever Guard
The Soft Start
TM
feature minimizes
splash-out by starting the mixer slowly
before increasing to the selected
speed. To further reduce the potential
for splash-out, always begin mixing
using the STIR speed, then gradually
move to higher speeds as needed. See
"Speed Control Guide".
Auto=Reset Motor Protection
If the Stand Mixer stops due to overload,
slide the speed control lever to OFF.
After a few minutes, the stand mixer
will automatically reset. Slide the Speed
Control Lever to the desired speed
and continue mixing. If the Stand Mixer
does not restart, see "Troubleshooting
Problems".