Venting; Wiring - Kenmore 153.335962 Owner's Manual

Installation Instructions (cont'd)
USE WITHOUT POWER CORD (cont'd)
3. A standard ½ condmt opemng has been made in the water
heater junction box for the conduit connection.
4. Use wire nuts and connect the power supply wiring to the
wires inside the water heater's junction box.
5. The water hearer must be electrically "grounded" by the
installer. A green ground screw has been provided on the
water heater's junction box. Connect ground wire to this
location. For complete grounding details and all allowable
exceptions, refer to local codes or in the absence of local
codes, with the latest edition of the National Electrical Code,
ANSI/NFPA 70.
6. Replace the wiring junction cover using the screw
provided.
WIRING DIAGRAM
O_bO_F
GAS
P_.8$URE
SV_TCq
I_OV 6A8
_ N
swtrcH
c-
AhqpRESSUrE
5ilz '_
|
1 _
Venting
I _WARNING
To insureproperventingof thisgas-fired water heater,the cor-
rect vent pipe diameter must be utilized• Any additions of
other gas appliances on.vent with this water heater will
adversely affectthe operationofthe water heater.
The combustion and ventilation air flow must not be obstructed.
• AWARNING ,, ]
The vent pipe from the water heater must be 3 diameter|
PVC schedule40 pipe and must slope upward I/4 inch per/
linearfoot. /
All vent gases must be completely vented to the outdoors of the
structure (dwelling).
AWARNING [
The water h.eate. r with draft hood installedmust be p_perly [
ventedto a chmmney whichterminatesoutdoors.Never oper-
I
ato thewater heaterunless it isventedto the outdoors and hasI
.a_dequate air supply to avoidHsksof improperopera, on, explo-
son or asphy'A_on.
AWARNING
I
Obstructedor deteriorat_ ventsymm_ maypresenta serious
healthriskor asphyxiation.
MIN. RISEV4"
PERFOOT
15
_,WARNING
Failureto haverequiredclearances betweenwater heater and
combustible m aterialwillresultin a fire hazard.