Page 1
Owners Manual FOR POTABLE WATER HEATING ONLY NOT SUITABLE FOR SPACE HEATING FOR USE IN MOBILE HOMES Model 153.330402 40 GaL High Altitude 153.330452 40 Gal. 153.330502 50 GaL High Altitude 153.330552 50 Gal. 153.330702 75 Gal. High Altitude 153.330752...
AREAS, Compliance solvents, fied by the installer or end user of the water heater with a locally prescribed installed in the designated opening in the water heater in _lace of the factory furnished valve.
Page 3
Mixing valves are available at plumbing supply or hardware stores. Follow manufac-...
Page 4
The water heater with draft hood installedmust be prop- I erly vented to a chimney which terminates outdoors. I Never operate the water heater unlessit is vented to the I outdoors and has adequate air supply to avoid risks of I improper operation, explosionor asphyxiation.
Product Specifications ... Materials and Basic Tools Needed ... Materials Needed ... Basic Tools ... -Installation "" Instructions Removing the Old Water Heater ... Facts to Consider About the Location ... Combustion Air and Ventilation for Appliances Combustion Air and Ventilation for Appliances Water Piping ...
Batterymarch Park, Quincy,MA 02269. • Read the "Safety Precautions" section, pages 2 through 4 of this manual first and then the entire manual carefully. If you don't follow the safety rules, the water heater will nor operate properly. It could cause DEATH, INJURY AND/OR PROPERTY DAMAGE.
You may or may not need all of these materi- als, depending on your type of installation. Water Heater Installation VENT ELBOW WATER HEATER INSTAL- LATION KIT WITH FLEXI- BLE CONNECTORS 3/4" OR 112" THREADED OR COPPER...
DEATH, SERIOUS BODILY INJUR_, OR PROPERTY DAMAGE. If this water heater will be used in beauty shops, barber shops, cleaning establishments, cleaning equipment, it is imperative that the water heater or water heaters be installed so that combustion and ventilation air be taken from outside these areas.
Installation Combustion Air and Ventilation for Appliances Located Unconfined Spaces Unconfined Space is a space whose volume is not less than 50 cubic feet per 1,000 Btu per hour of the aggregate input of all appliances installed in that space. Rooms communicating directly with the space in which...
It will harm the dip tube and damage the tank. • Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns of teflon tape around the threaded...
Compliance with such local requirements must be satisfied by the installer or end user of the water heater with a locally pre- scribed temperature-pressure relief valve installed in the desig- nated opening in the water heater in place of the factory fur- nished valve.
Obstructedor deterioratedventsystems may presenta serious healthHskor asphyxat on. Place the draft hood legs in the receiving holes on the top of the water heater. The legs will snap in the holes to give a tight fit. • Place the vent pipe over the draft hood. With the vent pipe in position, draft hood.
"OFF" the gasat eachappliance. Leaveall gasappli. ancesshutoff untilthe water heater installation iscomplete. A gas line of sufficient size must be run to the water heater. Consult the latest edition of National Fuel Gas Code ANSI Z223.1, also referred to as NFPA 54 and the gas company con- cerning pipe size.
TRAP A sediment trap shall be installed as close to the inlet of the water heater as practical at the time of water heater installation. The sediment trap shall be either a tee fitting with a capped nip- ple in the bottom outlet or other device recognized as an effec- tive sediment trap.
LEAKS Be sure to check all your gas pipes for leaks before lighting your water heater. Use a soapy water solution, flame. Check the factory gas fittings after pilot is lit and gas con- trol knob is still in "PILOT"...
Before attempting to light or rolight the water heater's pilot or turning on a nearby electrical light switch, be absolutely sure there is no accumulat- ecl gas in the area.
Page 18
Operating Instructions Lighting label on the water FOR YOUR If you do not follow these instructions exactly, a fire or explosion may resu t caus ng property damage, personal injury or loss of life. A. This appliancehas a pilot whichmust be lighted by hand.Whenlightingthe pilot,follow these instructions exactly.
Operating Instructions Temperature Regulation Due to the nature of the typical gas water heater, the water tern- perature in certain situations may vary up to 30°F higher or lower at the of use such as, bathtubs, showers, sink, etc. point...
Loose deposits on or around the burner can be removed by care- fully using the hose of a vacuum access door of the water heater. If the burner needs to be removed for additional and clean the burner and correct the problem burner to be cleaned.
Follow the lighting instructions in the "Lighting" section to restart the water heater. Housekeeping listed tempera- from any Vacuum around base of water heater for dust, dirt, and lint on a or pressure. regular basis. Combustible flammable the water heater.
A water heater may appear to be leaking when in fact the water is condensation. This usually happens when: • When a new water heater is filled with cold water for the first time.
MOUNTING) d. an excess of active hydrogen in the tank. This is caused by Smelly water may be eliminated or reduced in some water heater models by replacing the anode(s) with one of less active material, and then chlorinating the water heater tank and all hot water lines.
SHUT This water heater is equipped with an automatic tern. The high temperature shut off is built into the gas control valve. This system shuts off the gas supply to the water heater burners when high water temperatures resettable. If the high temperature shut off activates, the gas con- trol valve must be replaced.
Troubleshooting Leakage Checkpoints Use this guide to check a "Leaking" water heater. Many suspect- ed "Leakers"are not leaking tanks. Often the source of the water can be found and corrected. If you are not thoroughly familiar with your local gas codes,...
Page 26
Parts Order POWER MISER 12 GAS WATER HEATERS MODEL NUMBERS: 153.330402 40 Gal. High Altitude 40 Gal. 153.330452 153.330502 50 Gal. High Altitude 50 Gal. 153.330552 153.330702 75 Gal. High Altitude 153.330752 75 Gal List...
** Also available at most hardware stores. tReplaced only on return of damaged plate. Now that you have purchased your Gas Water Heater, should a need ever exist for repair parts or service, simply contact any SEARS Service Center or call 1-800-4-MY-HOME (1-800-469-4663)
Page 28
Sears will furnish a new current After one year and through 12 years from the date of purchase, when your Sears Kenmore water heater is used in a single-family residence and is installed and operated in accordance with the information in this manual, ifa part flailsdue to a materials or workmanship, Sears will furnish a replacement free of charge.