Power vented gas models with hot surface ignition, for potable water heating only, not suitable for space heating, not for use in mobile homes, 40/50 gallon natural (36 pages)
Summary of Contents for Kenmore THE ECONOMIZER 153.332111
Page 1
Owners Manual FOR POTABLE WATER HEATING ONLY NOT SUITABLE FOR SPACEHEATING FOR USE IN MOBILE HOMES Model 153.332111 39 Gal. High Altitude 153.332161 39GaL 153.332319 30 GaL High Altitude 153.332363 30 Gal. 153.332419 40 GaL High Altitude 153.332463 40 GaL 153.332563 50 Gal.
UTILITY AREAS, Compliance solvents, fied by the installer or end user of the water heater with a locally prescribed installed in the designated opening in the water heater in place of the factory furnished valve. For safe operation must plugged.
Page 3
Hixing valves are available at plumbing supply or hardware stores. Follow manufac-...
Page 4
Safety Precautions _WARNING The water heater wi_talled erly vented to a chimney which terminates Never operate the water heater unless it is vented to the I outdoors and has adequate air supply to avoid risks of improper operation, explosion or asphyxiation.
Product Specifications Materials and Basic Tools Needed ... Materials Needed ... Basic Tools ... Installation Instructions Removing the Old Water Heater ... Facts to Consider About the Location ... Combustion Air and Ventilation for Appliances Combustion Air and Ventilation for Appliances Water Piping ...
Batterymarch Park, Quincy,MA 02269. • Read the "Safety Precautions" section, this manual first and then the entire manual don't follow the safety rules, the water heater will not operate properly. It could cause DEATH, INJURY AND/OR PROPERTY DAMAGE.
You may or may not need all of these materi- als, depending on your type of installation. Water Heater Installation llI'l VENT ELBOW WATER HEATER INSTAL- LATION KIT WITH FLEXI- BLE CONNECTORS 3/4" OR I/2" THREADED OR COPPER...
Mineral buildupor sere may be extremely old water heater. This causesthe water heater to be much ] heavier than normal and this residue, if spilled out, could causestaining. Disconnect the vent pipe from the draft hood where they connect to the water heater.
• The location selected should be indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with tbe water _iping system as possible. The water heater, as all water...
Installation Instructions Combustion Air and Ventilation for Appliances Located Unconfined Spaces Unconfined Space is a space whose volume cubic feet per 1,000 Btu per hour of the aggregate input rating of all appliances installed in that space. Rooms communicating directly with the space in which the appliances...
It will harm the dip tube and damage the tank. • Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns o| teflon tape around threaded end of the threaded-to-sweat both ends of the _"...
Compliance with such local requirements must be satisfied by the installer or end user of the water heater with a locally pre- scribed temperature-pressure relief valve installed in the desig- nated opening in the water heater in place of the factory fur- nished valve.
AWARNING the water heater. The legs will snap in the holes to give a tight fit. in position, drill a small hole through both the vent pipe and draft hood. Secure them together with a sheet metal screw.
OFF the.gasat eachappliance.. Leave. a ll gasapph- Jancesshutoff untJIthe water heater nstallatmnmcomplete. J A gas line of sufficient size must be run to the water heater. Consult the latest edition of National Fuel Gas Code ANSI Z223.1, also referred to as NFPA 54 and the gas company con- cerning pipe size.
A sediment trap shall be installed as close to the inlet of the water heater as practical at the time of water heater installation. The sediment trap shall be either a tee fitting with a capped nip- ple in the bottom outlet or other device recognized tive sediment trap.
Consider About the Location" section. • Is there proper clearance between the water heater and any- thing that m!ght catch fire? See the "Facts to Consider About the Location section. • Do you have adequate...
"For YourSafety"on the coverpageof this manualthen leave the premises. Lighting and operating instructions are located on front of the water heater, above or to one side of the gas control valve. IIWARNING AN ODORANT IS ADDED TO THE GAS USED BY THIS WATER HEATER.
Page 18
Operating Instructions Lighting label on the water FOR YOUR If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliancehas a pilot whichmust be lighted by hand.Whenlightingthe pilot,followthese instructions exactly.
Operating Instructions Temperature Regulation Due to the nature of the typical gas water heater, the water tem- erature in certain situations may vary up to 30°F higher or ro_werat the point of use such as, bathtubs, This means that when the temperature the mark approximating 120°F, the actual water temperature...
Loose deposits on or around the burner can be removed by care- fully using the hose of a vacuum access door of the water heater. If the burner needs to be removed for additional and clean the burner and correct the problem burner to be cleaned.
OPEN the water heater drain valve to allow for tank draining. NOTE: If the water heater is going to he shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain.
This is caused by the corrosion Smelly water may be eliminated or reduced in some water heater models by replacing the anode(s) with one of less active material, and then chlorinating lines.
This water heater is equipped with an automatic gas shut offsys- tern. The high temperature shut off is built into the gas control valve. This system shuts off the gas supply to the water heater burners when high water temperatures are present. It is non- resettable.
Water in the water heater bottom or on the floor may be from condensation, loose connections, or the relief valve. DO NOT replace the water heater until a full inspection of all possible water sources is made and necessary corrective steps taken.
Parts Order THE ECONOMIZER 6 GAS WATER HEATERS MODEL NUMBERS: 153.332111 39 Gal. High Altitude 153.332161 39 Gal. 153.332319 30 Gal. High Altitude 153.332363 30 Gal. 153.332419 40 Gal. High Altitude 153.332463 40 Gal. 153.332563 50 Gal. List...
Page 27
# Not Illustrated Now that you have purchased your Gas Water Heater, should a need ever exist for repair parts or service, simply contact any SEARS Service Center or call 1-800-4-MY-HOME (1-800-469-4663). All parts listed may be ordered from any SEARS Service Center, most SEARS stores and by calling 1-800-366-PART...
Page 28
3. A charge will be made on service calls due to poor or incomplete installation. These include: For one year from the date of purchase, when your Sears Kenmore water heater is installed and operated in a single-family residence in accordance with the instructions in this manual, Sears will: 1.