Presser Foot; Changing The Presser Foot; Switch Off The Electrical Power - Pfaff coverlock 4872 Instruction Manual

Presser foot
•\ '4
\
'
With the standard presser foot 10 use the
setting "A" of the spring-loaded presser
foot latch for the cover stitch programs
(Progs. 1, 2, 3), the two-thread chainstitch
(Prog. 4), the 4-thread safety-stitch seam
(Prog. 191 and the 5-thread safety-stitch
seam (Prog. 20)-
The transparent presser foot F from the
accessories can also be used for the cover
stitch (Prog. 1, 2, 3) and the two-thread
chainstitch (Prog. 4).
For all other programs use the standard
presser foot 10 and the setting "B" for the
spring-loaded presser foot latch.
Changing the presser foot
Switch off the eectricaI power
To remove: Raise the needle(s) to the
highest position by turning the handwheel
towards you. Raise the presser foot and
press the lever A at the rear of the presser
foot holder. Pivot the presser foot clockwise
until the front half of presser foot clears
holder and remove by sliding foot away
from you towards back of machine.
To attach: Place the presser foot behind and
perpendicular to the sewing foot holder.
Pivot the presser foot counterclockwise until
the pin of the foot is directly under the
presser foot holder clamp. Lower the
presser foot lever and press lever A, if
necessary, until the foot then clicks into
place.
Check: Please lift the presser foot lever to
ensure that the presser foot is properly
locked into place.
I
11