Table of Contents
Advertisement
Presser Foot Lifter
Raise the presser foot by raising the presser foot lifter at
the back of the machine. Pressing the lifter up puts the
presser foot in extra lift position.
Always raise the presser foot lifter when threading. When
raised, the tension disks open and the threading becomes
easier.
Note: The machine will not sew if the presser foot is raised.
Lower the presser foot before starting to sew.
Changing the Presser Foot
Turn off the main power switch and unplug the machine.
•
Raise the presser foot.
•
Turn the handwheel toward you until the needles are
at the highest position.
•
Push the lever on the back of the presser foot ankle (A)
to release the presser foot. The foot will come off.
•
Place the new foot with the pin right underneath the
groove of the ankle (B). Lower the presser foot lever
to attach the foot. Raise the presser foot lifter again to
make sure the foot is attached properly.
Presser Foot Guide Lines
The toe of the presser foot has two guide lines.
The left guide line (A) is positioned at the left needle posi-
tion.
The right guide line (B) is positioned at the right needle
position.
A
B
A
B
ABOUT YOUR MACHINE – 9
Advertisement
Table of Contents
