Fedders 23-23-0321N-002 Installation & Operation Manual page 9

1
4, Gently twist with the screwdriver and unlock
the plastic projection by pulling the decora-
tive front slightly forward.
5, Swing the left side of the decorative front
away from the cabinet and unhook the
plastic projection on the right.
6, Remove air filter from tabs.
1, Carefully wash air filter with a mild detergent
and warm water. Rinse with clear water,
squeeze dry and replace.
8, To replace the decorative front, hook the
plastic projection on the right side then
swing the left side into position. Gently press
into position.
9, Reattach the screw in the control panel area.
Make sure the decorative front is secure
before reconnecting the plug and operating
the unit.
On other models with slide-out filters...
EVERYTWO WEEKS: C lean the filter.
"1, Turn Master Control to OFF.
2, Remove the air filter by grasping the top
corners and pulling it up and out of the unit.
3, Wash in hot soapy water, rinse and shake
dry.
4. Replace the filter, with the front of the filter
toward you.
5. To dry the filter thoroughly, run your unit for
a few minutes. Remember, only a clean filter
works properly and delivers top efficiency at
every setting.
1
Model and serial number
Louvered inserts
Discharge grill
Adjustable louvers
Air filter Tabs
Front panel
Inlet grill
Air filter
Note: Failure to keep air filter clean will result in poor air circulation. DO NOT operate without filter. This can
render the unit inoperative.
Proper use and care of your air conditioner will help ensure longer life of the unit. It is recommended to annually
inspect and clean the coils and condensate water passages. Expense of annual inspection is the consumers'
responsibilities.