Fedders 23-23-0321N-002 Installation & Operation Manual page 5

3
ii El
1/4"
Lower window sash
SIDE VIEW
5. Adjust leveling bolt so curved top of support
channel is 1/4" below top of window sill.
This downward tilt toward outside prevents
water from entering inside of room (Fig. 7).
6. Repeat steps 2 through 5 for second support
channel if required.
1. Keeping a firm grip on air conditioner, care-
fully center air conditioner in window open-
ing with the bottom bar sitting behind
window siN. Be sure cabinet maintains an
outward pitch. Air conditioner should slant
slightly downward on the outside as shown
by haft a bubble off on a carpenter's level.
This outward pitch prevents water from
entering the room (Fig,. 8).
8. Close window until it touches behind air
conditioner top bar. Slide finer panels out-
ward until they touch window sash tracks.
(Do not release grip on air conditioner until
lower window sash is in final position)
(Fig. 9).
!
k ._
3
k. 2
9
%" -j
( )
Window 0 0
sill _lllllllllllllllllllllll_iil . ...... _ Bottom bar \
Support channel
SIDE VIEW
Caution: Do not drill a hole in bottom pan. Unit is designed to operate with approximately 1/2" of water in bottom pan.