Advertisement
Available languages
Available languages
Review this chart to find do-it-yourself
solutions
for minor performance
problems. Any service
needed, other than those described
in this owner's manual, should be performed
by a Sears
authorized
service
representative.
!
Cleaner won't start.
PoorJobof dirt
pick-up.
Cleaner starts but
cuts off,
@
1. Unplugged at wal[out(eL
2, Tripped circuit breaker/blownfuse
at household service panel.
3. Loose hoseeleclrical connections.
4, Tripped thermal protectorin
canister,
1. Fufior cloggeddust bag,
2. Clogged airflow passages.
3. Dirty filters.
4. Wrong pile height setting.
5. Open suction co_treL
6. Hole in hose,
7. Worn Power-Mate_brushes.
1. P{ug in firmly,push ONIOFF switch to ON.
2. Reset circuitbreaker or replacefuse.
3, Reconnecthose ends, (page7).
4. Reset thermal protector, ( page 11),
1, Changebag, (page 12),
2. Clear airflow passages,(page 12),
3. Cleanibhangefilters. (page 13, 14).
4. Adjust setting, (page9).
5, Adjustcontrol, ( page 11).
6. Replacehose.
7, Change brushes. (page 17).
6.
9.
tO.
1,
2.
See BELT CHANGING AND BRUSH
CLEANING, (pages 15, 16),
Close and latch hood.
Worn or broken belt.
8 & 9.
Dirty brush or brush supports.
Canister hood open.
10,
Hose or hood electrical connections.
1.
Tripped overload protector in
2.
Power, M ate _.
Trippedthermal protector
3.
in canister,
Power-MaW' c onnections
1.
unplugged.
Wornor broken belt,
2 & 3.
Dirty brush or brush supports.
Tripped overload protectorin
4.
Power-Mate
TM
Wrong pile height setting,
1.
Suction tooslreng.
2.
Burnedout light bulb,
1,
Dirty power cord.
1.
Cord jammed.
2,
Wrongvacuuming patlern,
1.
Check connections, reconnect hose
ends,(page 7).
Remove any items thatmay be caught
or jammed, thenreset. If cleanerstarts
and stops again, clean brush and brush
supports, t hen reset,(pages 15.16).
Reset thermal protector,(page 11).
3.
Power-Mate _will not
1.
Plug in firmly,(page 6).
run when attached.
2.
See BELTCHANGINGAND BRUSH
3.
CLEANING, (pages15, 16),
4.
Check brush area for excessive lint
build-uporjamming.Clean brushand
brushsupports, t hen reset, (pages 15, 16).
Cleaner picks up moveable
1.
Adjustsetting,(pageg),
rugs ..or-Power-Mate"
2.
Open suction control,(page 11),
)ushee too bard.
Lightwon't work.
1.
Changelightbulb.(page 15).
Cord won't rewind.
1.
Clean the powercord.
2.
Pulloutcordandrewind.
Cleanerleaves marks
1.
SeeVACUUMINGTIPS, (page9)
on carpel
18
Advertisement
