Download Print this page

Kenmore 116.24212 Owner's Manual page 11

Advertisement

Available languages

Available languages

EDGE CLEANER
Active brush edge
cleaners are on both
sides of the Power-
Mate". Guide either
side of the Power-
Mate s along base-
boards or next to
furniture to help
remove dirt trapped at
carpet edges.
OVERLOAD PROTECTOR
The Power-Mate ®has
built-in protection
against
motor and belt damage
should the brush jam. If
the brush slows down or
stops, the overload
protector
button pops up
and shuts off the Power-
Mate _. The canister motor
will continue to run,
To correct problem: See
TROUBLESHOOTING,
To reset; Push in the overload protector
button.
SUCTION CONTROL
The suction
control allows
you to change
the vacuum
Suction
_Suction
suction for
different fabric
and carpet weights. Opening the control
decreases
suction for draperies and
lightweight rugs, while closing the control
increases suction for upholsteries
and
carpets.
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning
the brush area as
brush may suddenly
restart.
Failure
to do so can result in personal
injury.
POWER-MATE®STORAGE
SOME
MODELS
The lower wand has
a "U" shaped flange
in the area where
the power cord
attaches. The base
has a "U" shaped
slot near the front
caster,
The slot allows the
wands and Power-
Mate _ to be stored
with the canister to conserve
storage
space. The canister must be stored on
end for this feature to be used.
The wand will slip out of the slot as it is lift-
ed up for use and will slide into the slot as it
is lowered for storage.
THERMAL PROTECTOR
This vacuum
has a thermal protector which
automatically
trips to protect the vacuum
from overheating.
The thermal protector
turns the motor off automatically
to allow the
motor to cool in order to prevent possible
damage to the vacuum.
To reset: Turn off and unplug the vacuum
from the outlet to allow the vacuum to cool.
Check for and remove
any clogs. Also
check and replace
any clogged filters.
Wait approximately
50 minutes and plug
the vacuum
in and turn back on to see if
the thermal
protector
has reset. In some
cases, the unit may suddenly
restart.
DO
NOT leave unattended.
11

Advertisement

loading

This manual is also suitable for:

116.24213