Advertisement
Available languages
Available languages
1. Unplug cord from wail outlet. DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity
and dust build-
up, wipe outer surface of cleaner and
attachments.
•
CAUTION
Do not use attachments
if they
are wet. Attachments
used in
dirty areas, such as under a
refrigerator,
should not be used
on other surfaces
until they are
washed. They could leave marks.
Check motor safety filter occasionally and
change when dirty.
Electrical
Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the motor safety filter.
Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical
shock.
Remove the bag as outlined in the BAG
CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty.
It should be replaced regularly
depending
on use conditions.
The filter
CANNOT
be washed as it will lose its
dust trapping ability.
1. Lift the rub-
ber retainer
and pull out
motor safety
filter as
Shown.
2. Replace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
rubber retainer.
3. Replace the bag as outlined
in the BAG
CHANGING
section.
NEVER REUSE A DUST BAG. Very
fine materials,
such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause
it to burst before
it is full. Change
bag more often
when vacuuming
these materials.
13
Advertisement
