Table of Contents
Advertisement
Available languages
Available languages
SAVE
THESE
IIHSTRUCTUOHS
Read
aH instructions
before
using
th_s appliance,
When
using
gas or electr_caU
appniances,
basic
safety
precautions
shougd
be foHJowed,
including
the
following:
o All Ranges Can Tip
':::
:
o Injury To Persons
:..
Could Result
• Install Anti-tip
Device Packed With
Range
• See Installation
:::
Instructions
:
TooBs
you wHD need:
o Phillips head screwdriver
o 1 318" open end or adjustable wrench
1, Remove the bracket from the
prepack located inside the oven.
2, Decide whether the bracket will be
installed on the right or left side of
range location.
3, tf the bracket side of the range is
adjacent to a cabinet, place the
bracket against back wall and
cabinet as shown in Fig. !.
If there is no adjacent cabinet,
determine
where the location of
the range side (painted outside
panel) will be. Place the bracket
with its outside edge at this
location and against back wall.
See Fig. 2.
4, Determine whether you wil! anchor
the bracket to the floor or wall.
Make sure this location is clear of
electrical
wiring or plumbing.
Outside
Edge Of
Bracket
To Be
Flush With Left Or
Right Side Of Range
5_
=
m
Fig. 1
Fasten the bracket securely with
the screws provided.
Screws are
self-drilling
in wood, plywood,
particle and chip board, and most
metal framing,
if attaching to
masonry, you can buy suitable
screws and anchors at hardware
stores. Use a masonry drill bit to
drill the required holes.
Bracket 11 Wall
Screw Must Enter
\
II Plate
WoodOrMetal
_)_
Attachment To Wall
Fig, 2
Using the wrench, back out the
four leg levelers at least two turns,
See your installation
guide for
more leveling information
before
positioning
range.
Slide the range into place. Be sure
rear leg leveler fully engages
the
slot in the bracket. If range cannot
be moved back far enough for
rear teg leveler to enter bracket,
move bracket forward as required
and attach to floor in new location.
3
Advertisement
Table of Contents
