Kenmore 911.95579 Owner's Manual page 19

Serf-CleaningCycle
CLEANING
1. Remove the broiler pan and grid,
oven racks, utensils and any foil
that may be in the oven.
2. Soil on the front frame, 1" inside
the oven and outside the door
gasket, will need to be cleaned
by hand.
Front Frame
/
P Door Gasket ___
--'-- Door Liner
\
Clean these areas with hot water,
soap-filled steel wool pads or
cleansers such as Soft Scrub ® to
remove any soil. Rinse well with clean
water and dry.
3, Wipe up any heavy spillovers on
the oven bottom.
4. Do not clean the door gasket. The
fiberglass material of the oven
door gasket cannot withstand
abrasion. It is essential for the
gasket to remain intact. If you
notice it becoming worn, frayed or
displaced on the door, it should be
replaced.
The door gasket is designed to have
a 5-6" gap at the bottom of the door.
This allows for proper air circulation.
Door Panel
Gasket
Door Liner
it is normal for your oven door to give
the appearance of not having a good
seal against the range. This is due to
the gasket, The location of the gasket
on the oven door maintains a good
seal and prevents any heat loss.
_ tensills should never
be aeft _n the oven
during a seRf-cBean
cycBeo
The oven racks may be
cgeaned during the self.
cBean cycle, but wHB Bose
their Buster and become hard
to slide. If you choose to
Deave them in during the
cycge, wiping them down
with vegetabge oiB after the
cycle wHII heBp them sBide
easier.
For the first cnean cycDe,
vent the room w_th an
opened window or hood
vent. Th_s wiU reduce the
odor produced when heating
new parts,
19