JVC CA-FSH300 Instructions Manual page 56

in
[f you are having a proNem with your unit, check this list _br a possible solution before caHh]g tbr service.
[f you cannot salve _he proNem from _he hints given here, or file unit has been physically damaged, call a qualified person,
such as your deah: for service.
Symptom
Power does no[ come on.
No sound is heard.
P0ssibie Cause
The power cord is not connected to an
AC outlier.
° Com]ecfions are h]correct or k_ose.
• A pair ofheadphones is connected.
° MP3 disc is recorded wifl] packet
Action
[nselt the pklg imo file socket.
• Check all com]ections and make
corrections. (See pages 6 and 7.)
• Unplug _he headphones from the
PHONES jack.
• 1/cmmot be played. Replace the disc.
Hard to listen to broadcasts because of
n(;*i se,
The disc does not play.
[mpossi ble to record.
Operations are disabled.
Ul]aMe to operate the ul]it by Ihe remote
con tirol,
° Antemlas are disconnected.
• The AM k_op antemm is too close to
fl_e unit.
• The FM antenna is not properly
extended and positioned.
The disc is upside down.
• Reconnect fl_e antenna corlTectly and
securely.
• Change the position and direction of
the AM k_op m_tenna.
• Extend FM antemm and orienl to the
best reception position.
Put file disc hi with the label side up.
Small tabs on fl_e back of the cassette are Cover fl_e holes wifl_ adhesive tape.
removed.
The built-in microprocessor has
malfunctioned due toexternal electrical
interference.
• The palh between the remote conUTol
and file remote sensor on the unit is
blocked.
• The batteries are exhausted.
• You are ush]g the remote control too
tier fl'om the unit.
Unplug the AC power cord fl_en plug it
back in.
* Remove the obstructP.;*lL
• Replace the batefies. (See page 7.)
• Signals camot reach the remote
sensor. Move closer to the unit.
23